NARDA ELT-400 - Annex A: Default Values; Parameter Default Settings

A-1
Annex A: Default values
The table below lists the default values (ex-works settings) of the ELT-400:
• when the instrument is switched on,
• after the remote control command SYST:DEFAULTS has been executed.
The following table shows the status of the major parameters after various
actions.
Parameter Default setting
RANGE HIGH
MODE Depends on the instrument version selected
(built-in operating modes)
• Default is the operating mode shown farthest to
the left on the basic instrument.
DETECT
(detection mode)
Depends on the mode selected
• RMS if a field strength mode is preset
• STND if an Exposure STD mode is preset
MAX HOLD
(display function)
OFF (current measurement value is displayed)
LOW CUT
(lower frequency range limit)
30 (Hz)
Status display
• MAX HOLD
• OVLD
Cleared
Cleared
CALC:BAT OFF (battery status not returned at the end of a
result transfer)
CALC:OVLD OFF (overload status not returned at the end of a
result transfer)
SYST:KLOCK OFF (no keypad lock)
SYST:XONXOFF ON (data transfer protocol activated)
Table A-1 Default values