NARDA ELT-400 - Parameter Status After Actions

Annex A: Default values ELT-400
A-2
Parameter Status of parameter after action
Change of
measuring
range
[RANGE]
Change of
operating
mode
[MODE]
Change of
lower frequency
range limit
[LOW CUT]
Change of
probe
Status of parameter after remote control command
SET:
RANGE
SET:
MODE
SET:
LOW_CUT
RANGE As set Unchanged Unchanged Unchanged
MODE Unchanged As set Unchanged Unchanged
DETECT
(detection mode)
Unchanged Variable
1
Unchanged Unchanged
MAX HOLD
(display mode)
OFF OFF OFF OFF
LOW CUT (lower
frequency range limit)
Unchanged Unchanged As set Unchanged
Measured values /
display status of the
following instrument
functions:
• RMS, PEAK, STND
• MAX HOLD
• OVLD
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
CALC:BAT Unchanged Unchanged Unchanged Unchanged
CALC:OVL Unchanged Unchanged Unchanged Unchanged
SYST:XONXOFF Unchanged Unchanged Unchanged Unchanged
1 Depends on the selected operating mode:
- RMS in Field strength mode
- STND in Exposure STD mode
Table A-2 Status of major parameters after various actions