X Series User Manual
© National Instruments | I-3
timing summary, 4-46
triggering, 4-40
troubleshooting, C-1
analog output
circuitry, 5-1
connecting signals, 5-5
data generation methods, 5-3
fundamentals, 5-1
getting started with applications in
software, 5-11
glitches on the output signal, 5-2
reference selection, 5-2
signals, 5-5
AO Pause Trigger, 5-7
AO Sample Clock, 5-8
AO Sample Clock Timebase, 5-10
AO Start Trigger, 5-6
timing signals, 5-5
trigger signals, 5-4
triggering, 5-4
troubleshooting, C-2
analog source, triggering, 11-2
analog trigger, 11-2
accuracy, 11-6
actions, 11-3
improving accuracy, 11-6
analog window triggering, 11-6
analog-to-digital converter
MIO X Series devices, 4-2
Simultaneous MIO X Series devices,
4-36
ANSI C documentation, B-3
AO FIFO, 5-1
AO Pause Trigger signal, 5-7
AO reference selection, 5-1
AO reference selection settings, 5-2
AO Sample Clock, 5-1
AO Sample Clock signal, 5-8
AO Sample Clock Timebase signal, 5-10
AO Start Trigger signal, 5-6
ao/PauseTrigger, 5-7
ao/SampleClock, 5-8
ao/StartTrigger, 5-6
APFI <0, 1> terminals, 11-2
applications
counter input, 8-3
counter output, 8-26
edge counting, 8-3
applying rubber feet, 1-7
arm start trigger, 8-45
avoiding scanning faster than necessary (MIO
X Series devices), 4-8
B
buffered
edge counting, 8-4
hardware-timed acquisitions
MIO X Series devices, 4-9
Simultaneous MIO X Series
devices, 4-39
hardware-timed generations, 5-3, 6-12
position measurement, 8-23
two-signal edge-separation
measurement, 8-25
bus
interface, 10-1
RTSI, 9-4
C
cable management, 1-7
cables, 2-3
choosing for your device, 1-10
custom, 2-7
NI 6320, A-3
NI 6321/6341, A-7
NI 6323/6343, A-11
NI 6345/6355, A-13, A-17, A-20
NI 6351/6361, A-26
NI 6353/6363, A-32
NI 6356/6366/6376, A-38
NI 6358/6368/6378, A-40
NI 6365, A-43
NI 6374, A-45
NI 6375, A-48
X Series devices, 2-4
calibration, 1-4
circuitry, 2-3
cascading counters, 8-45
cDAQ chassis
example programs, B-1
To Next Page
Loading...
Need help?
General
