National Instruments cDAQ-9133 User Manual

© National Instruments | 1-1
1
Getting Started with the
cDAQ Controller
The National Instruments four-slot CompactDAQ cDAQ-9132, cDAQ-9134, and cDAQ-9136
controllers and the eight-slot CompactDAQ cDAQ-9133, cDAQ-9135, and cDAQ-9137
controllers are available as a Windows Embedded Standard 7 (WES7) or a LabVIEW Real-Time
system. NI cDAQ-9132/9133/9134/9135 controllers feature the dual-core 1.33 GHz Intel Atom
processor. NI cDAQ-9136/9137 controllers feature the quad-core 1.91 GHz Intel Atom
processor.
This chapter contains information about getting started with the cDAQ controller with Windows
and with LabVIEW Real-Time:
• For NI cDAQ-9132/9133/9134/9135/9136/9137 for Windows, refer to the Installing the
cDAQ Controller for Windows section
• For NI cDAQ-9132/9133/9134/9135/9136/9137 for LabVIEW Real-Time, refer to the
Installing the cDAQ Controller for LabVIEW Real-Time section
The cDAQ controller features a number of standard interfaces and combines with C Series
modules to measure a broad range of analog and digital I/O signals that can be logged to the local
hard drive or an SD card. For specifications, refer to the specifications document for your cDAQ
controller. For module specifications, refer to the documentation included with your C Series
module(s) or go to
ni.com/manuals.

National Instruments cDAQ-9133 Specifications

General

Brand	National Instruments
Model	cDAQ-9133
Category	Controller
Language	English