1-4 | ni.com
Chapter 1 Getting Started with the cDAQ Controller
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits for
electromagnetic compatibility (EMC) stated in the product specifications. These requirements
and limits provide reasonable protection against harmful interference when the product is
operated in the intended operational electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may
occur in some installations or when the product is connected to a peripheral device or a test
object. To minimize interference with radio and television reception and prevent unacceptable
performance degradation, install and use this product in strict accordance with the instructions
in the product documentation.
Furthermore, any modifications to the product not expressly approved by National Instruments
could void your authority to operate it under your local regulatory rules.
Caution To ensure the specified EMC performance, product installation requires
either special considerations or user-installed add-on devices. Refer to the Installing
the cDAQ Controller for Windows section or Installing the cDAQ Controller for
LabVIEW Real-Time section for further information.
Caution To ensure the specified EMC performance, operate this product only with
shielded cables and accessories. Note that the input DC power cables may be
unshielded.
Caution To ensure the specified EMC performance, do not connect V2 to a DC
mains supply or to any supply requiring a connecting cable longer than 3 m (10 ft).
A DC mains supply is a local DC electricity supply network in the infrastructure of a
site or building.
Caution To ensure the specified EMC performance, the length of any cable
connected to the video and USB host ports must be no longer than 3 m (10 ft).
The length of any cable connected to the RS-232 port must be no longer than
30 m (100 ft).
Caution The USB device port is intended for use in device configuration,
application deployment, debug, and maintenance.
To Next Page
Loading...
Need help?
General
