National Instruments PCI-8430 - Page 191

WhydoestheNIEthernetDeviceConfiguration
utilitylistmyserialENETinterfaceas*BUSY*
whenIknowmynetworkusesDHCP?
Foruptooneminute,theserialdeviceserverattemptstoretrieve
networkparametersfromaDHCPserver.Duringthistime,*BUSY*
appearsintheutilitydisplay.Ifthisstatusdoesnotchange,thereare
severalreasonswhyDHCPmayfailtorespond.Oneofthemostlikely
reasonsisthatyoursubnethasnomoreavailableaddressestoassign
usingDHCP.Consultyournetworkadministratortodeterminethespecific
reasonfortheproblem.