National Instruments PCI-8430 - Page 77

changethehostnameoftheEthernetdevice.IfyouselectUse
thefollowingIPsettings,enterthenetworkparametersyou
havechosenforthehostIPaddress,subnetmask,gatewayIP,
andDNSserverIP,asintheexampleshownbelow.Referto
UsingStaticIPParametersformoreinformation.
SpecifyingIPSettings
NoteTheIPsettingsshownaboveareshownonlyasa
formatexample.
4. Youcanenteranoptionalcommenttohelpyouidentifythe
device.
5. ClickOKtoconfigurethedevice,orCanceltoexitwithoutsaving
theconfigurationchanges.
6. ClickExit(orCancel)toclosetheNIEthernetDevice
Configurationutility.
Thedeviceautomaticallyrebootswiththenewconfigurationineffect.