National Instruments SCXI-1000 User Manual

Index
© National Instruments Corporation I-3 SCXI-1120/D User Manual
floating AC-coupled signal connections
(figure)
SCXI-1120, 3-6
SCXI-1120D, 3-7
floating signal connections referenced to
chassis ground (figure), 3-5
front connector, 3-3 to 3-7
analog input channels, 3-5 to 3-7
pin assignments (figure), 3-3
signal descriptions (table), 3-4
temperature sensor connections, 3-7
G
gain determination, calculating, 4-7
gain jumpers for SCXI-1120/D, 2-10 to 2-12
allocation (table), 2-10 to 2-11
positions (table), 2-11 to 2-12
grounding, jumper W46 settings (table),
2-8 to 2-9
ground-referenced signal connections
(figure), 3-5
I
installation. See also configuration.
hardware installation, 2-14
unpacking the SCXI-1120/D, 1-3
J
jumpers
analog configuration, 2-8 to 2-13
gain jumpers, 2-10 to 2-12
jumper W41, direct temperature
connection, 2-10
jumper W46, grounding, shielding,
and reference-mode selection,
2-8 to 2-9
SCXI-1120 filter jumpers,
2-12 to 2-13
SCXI-1120/D filter jumpers, 2-13
digital signal connections, 2-4 to 2-8
jumper W42 and W43, 2-5 to 2-6
jumper W44, 2-6
jumper W45 (table), 2-8
fixed jumpers, 2-3
parts locator diagram, 2-2
steps for configuring, 2-4
user-configurable jumpers, 2-3
L
LabVIEW software, 1-3
LabWindows/CVI software, 1-4
M
manual. See documentation.
MCH0± through MCH7± signals (table), 3-9
module configuration. See configuration.
Module ID Register, 4-4
MTEMP signal (table), 3-4
multiplexed mode, 4-10 to 4-11
N
National Instruments application software,
1-3 to 1-4
National Instruments Web support, B-1 to B-2
NI-DAQ driver software, 1-4 to 1-5
O
online problem-solving and diagnostic
resources, B-1
operation of SCXI-1120/D. See theory of
operation.
OUTREF signal (table), 3-9

National Instruments SCXI-1000 Specifications

General

Brand	National Instruments
Model	SCXI-1000
Category	Control Unit
Language	English