Solid Bus Comp
Solid B-Compression effect
Also available as a fully-fledged product in its own right, this virtual reproduction of a leg
endary compressor adds presence and drive to your drums without blurring the detail.
▪
The
ATTACK
knob adjusts the amount of time in milliseconds that it takes for the com
pressor to reach the ratio after the input signal exceeds the threshold level.
▪
The
RELEASE
knob adjusts the amount of time in milliseconds that the compressor will
take to stop affecting the sound after the input signal falls below the threshold.
▪
The
THRESHOLD
knob adjusts the level in dB that the input signal must exceed before
the compressor starts affecting the sound.
▪
The RATIO knob controls the amount of compression expressed as a ratio of “input lev
el” to “output level change”. The higher the RATIO knob is set, the more the output
level will be reduced as the sound goes beyond the threshold.
▪
The MIX knob allows you to add the dry signal to the mix as well, for a parallel com
pression sound.
▪
The MAKEUP knob allows you to increase the overall output level of the compressed
sound.
▪
The OUTPUT knob on the right side adjusts the overall output level.
The Performance View
Mixer Page
STUDIO DRUMMER - Manual - 21
To Next Page
Loading...
Need help?
General
