NV30/NV40 Operations and Maintenance Manual Operating the transmitter
Issue 3.3 2014-12-10 Page 2-61
Factory Settings
Values for critical parameters are set using the Factory Settings page (see Figure 2.42), which is
accessed from the
Menu page. To use this page, simply select an item from the list on the left-side of
the page to open related information on the right-side of the page.
This section includes the following topics:
• System configuration on page 2-62
• Transmitter type on page 2-63
• Scaling on page 2-64
• Thresholds on page 2-65
• Redundant supplies on page 2-66
• IPA bias balance on page 2-67
• PA field bias on page 2-69
Figure 2.42: Factory Settings
WARNING: Device settings are established at the factory and should not
require any adjustment. These settings affect critical system protection
circuits. Making changes to these settings may void your warranty.
Contact Nautel before making changes.
To Next Page
Loading...
