Nautel NV30 - Page 99

NV30/NV40 Operations and Maintenance Manual Operating the transmitter
Issue 3.3 2014-12-10 Page 2-81
Changing the password
To change your password, press the Change Password button. A menu appears that prompts you to
enter the old password, new password and confirmation of the new password. Press Apply to save or
Cancel to exit this menu (see Figure 2.62 on page 2-82).
Setting auto login (local only) status
When checked (
) the selected user account will be automatically logged in to the transmitter with all
the rights and priveleges that have been assigned to that user. There may only be one autologin user at
any given time; when the Auto Login check box is selected for one user account, it is automatically
cleared on all other users. When not checked, the transmitter will not login automatically and will
instead prompt for username and password when it boots up. It should be noted that only accounts
with Administrator level permissions can set or remove Auto Login status.
Changing permissions
You must be an Administrator to edit this function.
All users have permission to change their own username and password. You can customize the
permissions assigned to a user or simply pick a predetermined set of permissions based on the user
type.
Procedure to change user permissions (see Figure 2.62 on page 2-82):
1. Open the User Accounts page.
2. Select a user from the Users list to display the permissions for that user in the center of the
Permissions window. The permissions associated with the selected user are identified with a
checkmark ().
3. Press on User Type to reveal a drop-down menu and select a new type of user.
4. If the user type in step 3 is
Custom, set individual permissions. Under Permissions, place a
checkmark (
) beside each permission that you want to associate with the user. The boxes
work like a toggle - select the checkbox to place a checkmark and select again to remove the
checkmark. Choose one or more of the following options:
•
Activate/Modify Preset - Allows the user to modify presets and change the active preset.
•
Power Control - Allows the user to change the power set point of the transmitter..
• Delete Logs - Allows the user to remove log entries.
•
RF On/Off - Allows the user to turn the RF output on and off..