Nautilus ONE™ Tower Shroud Removal
Tools Required: 9/16” Socket Wrench
9/16" Wrench
5/32" Hex Wrench
Remove the Top Cover
1-1 Remove the two mounting screws on the rear of the
top cover with a 5/32" Hex wrench (Figure 1).
1-2 Remove the cover by lifting the rear edge up and
forward to clear the front slot (Figure 2).
Remove the Handlebar
2-1 Remove the (4) 3/8" hex head bolts, (4) lock washers
and (4) lock nuts with a 9/16" socket wrench.
2-2 Carefully lift the handlebar and place aside
(Figure 3).
Remove the Rear Shroud
3-1 Remove one screw at the top of the shroud with a
5/32" Hex wrench. Lift up and out of the bottom slot
(Figure 4).
(Shroud Removal continued on next page)
Figure 1
Service Procedures
Figure 2
Figure 3
Figure 4
Service Manual
5
To Next Page
Loading...
Need help?
General
