Nautilus R628 - Connect the Cables and Attach the Console Mast to Frame Assembly; Remove Hardware from Console

15
8. Remove Hardware from Console
NOTICE: Do not crimp the cables.
Note: Hardware (*) is pre-installed and not on the Hardware Card. If desired, apply the French Canadian overlay to
the Console face.
X4
#2
*
15
7. Connect the Cables and Attach the Console Mast to Frame Assembly
NOTICE: Do not crimp the cables. Install the front hardware on the Console Mast first, then the side hardware.
14
13
A
E
6mm
X4
F