139
6. Make sure that the locking mechanism is engaged. Carefully pull back on the
walking deck and make sure that it does not move. When you do this, keep clear of
movement path in case the treadmill lock is not engaged.
Do not lean against the treadmill when it is folded. Do not put items on
it that could cause it to become unstable or fall.
7. Using a #2 Phillips screwdriver loosen the indicated screw on both of the Rear
Roller Covers and remove them.
To remove the Right Roller Cover, the Tilt Release Handle must be
pushed for additional clearance. Be sure not to pull down on the Deck
when the Tilt Release Handle is pushed or the Deck may begin to lower.
8.Makesurethereissufcientspacetolowerthewalkingdeck.
Keep a minimum clearance behind the machine of 79” (2 m) and 24”
(0.6 m) on each side. This is the recommended safe distance for
access, movement and emergency dismounts from the machine.
9. Make sure there is no object on or around the treadmill to spill or cause blockage
from the fully unfolded position.
10. Slightly push the walking deck forward toward the console, and then push the
Deck Release Handle until the locking tube releases and you can pull the walking
deck away from the console. Hold up the rear of the walking deck, and move to the
side of the machine.
Keep clear of the movement path of the walking deck.
11. The hydraulic lift is set up to drop gradually. Hold onto the walking deck until
approximately2/3ofthemovementdown.Makesurethatyouuseproperlifting
technique; bend your knees and keep your back straight. Be aware that the walking
deck can possibly drop quickly in the last part of the movement.
To Next Page
Loading...
Need help?
General
