23
Replace Console if
blockage cannot be
removed or if fan still does
not turn off.
Unplug machine from
power source and remove
any blockages, then reset.
Console Issues (page 2 of 2)
BEGIN HERE:
Fan will not turn on or off.
Turn machine power off
for 5 minutes and retry.
Disconnect machine from
power for 1 minute, then
follow Service Mode
Procedure 3 to reset the
Console.
Speed is incorrect.
Refer to the Owner’s
Manual “Console Setup
Maode”, ensure that the
correct units of measure
are set.
NO
Is the issue still
present?
YES
Issue resolved
Follow Service Mode
Procedure 2 to check
firmware version and error
codes.
Contact
Tech Support at
800.861.7401
for further assistance.
If Console will not light up, follow
“Unit will not power on” Troubleshooting
Procedure.
If the units of measure are incorrect, follow the
Owner’s Manual instructions to correct the
setting before beginning these steps.
Console continuously
cycles through program
screens.
Console is in demonstra-
tion mode. Hold down the
PAUSE/STOP button and
Down arrow button
together for 3 seconds.
To Next Page
Loading...
Need help?
General
