Combination water heater operation
█
Capacity Control of The Whole
Please follow this procedure if restricting heat capacity is needed
Please turn off the power of Remote
Controller by pressing ON/OFF button.
It the DHW and Stand By buttons are
pressed simultaneously, the system goes
into „HEAT CAPACITY CONTROL‟ mode.
At this time, press the DHW and Heating
button simultaneously for 3 seconds.
Then the clock rotates clockwise and the
current heat capacity is displayed.
Use the center dial to adjust the heat
capacity. (Range 30 ~ 100 %)
“Program” button to complete setting.
If setting is completed Remote
Controller will return “OFF” state.
To Next Page
Loading...
Need help?
General
