40
LED status display APPCON 3000
The LED is either off or ashing in different colors to indicate the
status (red, green or blue).
Initial start-up:
When delivered, your APPCON 3000 is in deep sleep, the LED is
off. To wake it up, simply connect the APPCON to a hub dynamo
or a USB charger. After a few seconds the LED of the APPCON
welcomes you in all colours. APPCON 3000 is now booted and
ready for use.
LED ashes blue:
APPCON 3000 is switched on and can charge a connected USB
device. Bluetooth is ready for pairing. Everything is perfect and
works as it should.
LED constant blue:
APPCON 3000 is switched on and can charge a connected USB
device. It is paired with your mobile phone, tachometer functions
are active.
LED ashes green slowly for 60 seconds:
APPCON 3000 has switched off the Bluetooth connection and
keeps the USB output open for 1 minute. If the USB output is not
used, the APPCON goes into tent mode. With the magnet you can
open the USB port again at any time. Is the USB Port open the
green LED is ashing.
LED ashes red:
APPCON 3000 is switched on. Its battery is empty. Bluetooth is
ready for pairing, but it cannot charge a connected USB device.
LED constantly red:
APPCON 3000 is switched on. Its battery is empty. It is paired with
your mobile phone via Bluetooth, tachometer functions are active,
it can only charge a connected USB device from a charge of 17%.
To Next Page
Loading...