X350 and X550 User Manual
Page 8
Four users can share a single PC with one X350 kit. With two X350 kits, you can
add six users to a PC for a total of seven users sharing one PC.
Minimum System Requirements
Host Computer
Refer to the “vSpace Operating System Support Matrix” in the NComputing Knowledge
Base for the latest information on supported operating system versions (note that unless
specifically listed in the OS support matrix document, a new OS service pack may not be
supported by then-current vSpace software). As a best practice, before deploying any
new OS service pack, first confirm vSpace support per above and then test in a
representative non-production environment with all your applications before rolling out to
your complete environment (e.g. you should not allow automatic updates).
Microsoft Windows Licenses. You are licensed by NComputing to use the vSpace
software under the terms of the End-User License Agreement (EULA). You must also
acquire the appropriate number of Windows Server licenses and Client Access Licenses
(CALs) for each device or user accessing Windows Server software. You cannot use
the vSpace software with Windows Client software (i.e., Windows Vista, Windows 7)
unless a single user and no other user accesses the same Windows Client software at
any one time, or you are authorized to do so under an applicable license from Microsoft
or as expressly set forth in the “Microsoft Windows Server to Windows XP License
Rights” section of the NComputing EULA.
In all cases, your rights and obligations with
respect to the use of vSpace software with Windows Server software and Windows
Client software are defined by both the NComputing vSpace software EULA and the
applicable Microsoft Software License Agreement or EULA. For more information on
licensing with Microsoft operating systems see: www.ncomputing.com/mslicensing
Each X550 PCI card requires an available full-height PCI slot, while each X350 requires
either an available full-height or half-height PCI slot.
For a single X350 kit with 1-4 users, a host PC should have a minimum of a 2.4 GHz
processor or any dual-core processor and 2 GB RAM. For a single X550 kit with up to 6
users, a 3.0 GHz processor or any dual- or quad-core processor with at least 3 GB of
RAM is recommended. You should double the amount of RAM for 64-bit systems.
For a dual card installation (two X350 or two X550 kits with 7 to 11 users), a host PC
should have a minimum of a 3.0 GHz processor or an equivalent dual- or quad-core
processor and 4+ GB RAM (for 64-bit hosts, 6+ GB is recommended).
Note that performance varies based on the shared computer specifications and what
applications are being run. For multimedia applications, benchmark testing has shown
Microsoft Windows Server to Windows XP License Rights. If you have licensed the appropriate number of Windows
Server operating system and associated Client Access Licenses for simultaneous access by multiple users to the host
computer, you may install and run vSpace on a separately licensed Windows XP operating system for simultaneous
access by multiple users in lieu of the Windows Server operating system. You may only install and use either the
Windows Server operating system software or the Windows XP Client operating system software but not both. Microsoft
does not provide any support for vSpace or for the Windows XP operating system in this configuration; you should seek
support from NComputing for issues relating to vSpace and its use with the Windows XP Client operating system.
To Next Page
Loading...
Need help?
General
