Chapter 1: Installation 1-5
Connecting the AC Power
Connect the power cord to the AC adapter. (See Fig. 1-5)
Connect the AC adapter's DC output connector to the DC Power Jack
of the monitor.
Connect the power cord to an AC power source.
Figure 1-5
Warning
Please install a "Surge Protector" device between the AC Adapter and the
electrical wall outlet for added protection against power surges to prevent the
effects of sudden voltage variations from reaching the LCD Monitor. Sudden
power surges may damage your monitor.
Setting Up the LCD Monitor
1. Make sure the AC Adapter is connected to the LCD Monitor.
2. Turn on the LCD Monitor's power switch, located on the bezel of
the monitor.
Power Management System
This LCD Monitor complies with the VESA DPMS (version 1.0) Power
Management guidelines. The VESA DPMS provides four power saving
modes through detecting a horizontal or vertical sync. signal.
When the LCD Monitor is in power saving mode, the monitor screen
will be blank and the power LED indicator will light amber.
To Next Page
Loading...
