3-6 Chapter 3: Technical Information
Troubleshooting
This LCD Monitor has pre-adjusted using factory standard VGA
timings. Due to the output timing differences among various VGA
cards in the market, users may initially experience an unstable or
unclear display whenever a new display mode or new VGA card is
selected.
Attention
This LCD Monitor Supports Multiple VGA Modes.
Refer to the Standard Timing Table for a listing of modes supported by this
LCD Monitor.
PROBLEM Picture is unclear and unstable
If there’s no display on the LCD Monitor, please perform the following
steps :
1. Enter PC to “Shut Down Windows” status while you’re in MS-
Windows environment.
2. Check the screen to see if there’s any black vertical stripes appear.
If there are, take advantage of the “Clock” function in OSD menu
and adjust (by increment or decrement numbers) until those bars
disappear.
3. Move to “Phase” function in OSD Menu again and adjust the
monitor screen to its most clear display.
4. Click “No” on “Shut Down Windows” and back to the normal PC
operating environment.
PROBLEM There is no picture on LCD Monitor
If there’s no picture on the LCD Monitor, please perform the following
steps:
1. Make sure the power indicator on the LCD Monitor is ON, all
connections are secured, and the system is running on the correct
timing. Refer to Chapter 3 for information on timing.
To Next Page
Loading...
