Chapter 3: Technical Information 3-7
2. Connect your PC system to another external CRT. If your PC
system Functions properly with a CRT Monitor but it does not
function with the LCD Monitor, the output timing of the VGA card
may be out of the LCD’s synchronous range. Please change to an
alternative mode listed in the Standard Timing Table or replace the
VGA card, and then repeat steps 1.
PROBLEM There is no picture on LCD Monitor
If you have chosen an output timing that is outside of the LCD
Monitor’s synchronous range (Horizontal: 31 ~ 48 KHz and Vertical: 56
~ 75 Hz), the OSD will display a “Out of Range” message. Choose a
mode that is supported by your LCD Monitor.
Also, if the signal cable is not connected to LCD monitor at all or
properly, the monitor screen will display a message “No Input Signal”.
To Previous Page
Loading...
