NCR 7607 - Page 121

BIOS Setup 7-111
Configuration Choices
Configuration Choice
Settings
Notes
SATA DEVSLEP Idle Timeout
Config
[Disabled]
Serial ATA Port 1/2/3/4/5 Empty If other Ports are in use
settings have the
possibility of changing. 6
Ports in total.
Software Preserve Unknown
Port 1/2/3/4/5 [Enabled]
Hot Plug [Enabled]
Mechanical Presence
Switch
[Enabled]
External SATA [Disabled]
Spin Up Device [Disabled]
SATA Device Type [Hard Disk Drive]
Topology [Unknown]
Device Sleep [Disabled]
SATA DEVSLEP Idle Timeout
Config
[Disabled]
Serial ATA Port 2 Empty
► PCI Subsystem Settings
PCI Bus Driver Version A5.01.08
PCI Latency Timer [32 PCI Bus Clocks]
PCI-X Latency Timer [64 PCI Bus Clocks]
VGA Palette Snoop [Disabled]
PERR# Generation [Disabled]
SERR# Generation [Disabled]
Above 4G Decoding [Disabled]
Don't Reset VC-TC Mapping [Disabled]
►PCIHot-Plug Settings