Chapter 7: Programming 7-19
Tone Length (Milliseconds)
The Hex C tag permits you to set the length of the Good Read Tone by
listening to it. Each time you scan the Hex C tag, the tone length
changes from a minimum of 25 milliseconds to a maximum of 250, and
then back again. End this mode by scanning the End tag or another
valid Hex tag.
Tone On/Off
The Hex A tag sets the Tone On/Off programming mode,
which offers two options, On and Off. The Hex 0 tag turns
the Good Read tone off and the Hex 1 tag turns the Good
Read Tone on. The default is to turn the Good Read Tone on.
Tone Volume
The Hex D tag permits you to select the volume of the Good Read tone
by listening to it as you repeatedly scan the Hex D tag. End this mode
by scanning the End tag or another valid Hex tag.
Program Example
Following is an example of a completed Good Read Tone
programming worksheet. In this example, the only selection that can be
made beforehand is the tone on/off, which is selected to be on. The
other adjustments are selected by listening to the tone as you
repeatedly scan the appropriate Hex tag.
Your Program
1
Frequency
Tone
B
Tone
Length
C
Tone
Volume
D
1
1
B
C
D
** *
Not-On-File
Tone Volume
E
E
*
* Scan Hex tag repeatedly for desired setting.
Tone
On/Off
A
B052
Good Read Tone
*
To Next Page
Loading...
