NCR 7870 - Page 192

7-76 Chapter 7: Programming
5. Repeat steps 1 through 4 to set the second Coupon Select 1
parameter.
Suggested Programming Sequence
• Programming Mode
• Hex 3 and Hex 8
• Hex 1
• Save and Reset
• Programming Mode
• Hex 3 and Hex 8
• Hex 3
Note:
Scanning the Default tag disables all options.
The second part is to Set Terminal Coupon Select 2 Parameter.
1. Scan the Programming Mode tag.
2. Scan the Hex 3 and Hex D tags to select this parameter.
3. Scan a Hex 0 through Hex 7 tag to set a Coupon Select 2 parameter.
Coupon Select 2 Parameter Disable Enable
Coupon & P5 or 128 optional (EAN-99)
Hex 0 Hex 1
Coupon &128 mandatory (EAN-99) Hex 2 Hex 3
Markdown Tone Hex 4 Hex 5
Early Tone for Optional Add-On Hex 6 Hex 7
4. Scan the Save and Reset tag to save the program.
5. Repeat steps 1 through 4 to set the other option, if needed.
Note:
Scanning the Default tag disables all options.