NCR SelfServ 22e ATM Site Preparation
B006-6902-D000 5
SITING THE ATM
The SelfServ 22e is only suitable for installation in an interior environment. It must be
installed on a non-combustible, clean, solid, level surface capable of supporting the
maximum weight of the device, including media, and be placed within easy reach of
power outlets. It must also be positioned away from heat sources, direct sunlight or any air
conditioning equipment.
Allow sufficient room for installation and servicing requirements.
Note: Early SelfServ 22e ATMs do not have a power disconnect device (on/off switch).
If your ATM does not have the power switch shown below then an easily accessible,
switchable, mains socket is required to allow safe isolation from the power supply,
resetting and power cycling of the ATM.
To Next Page
Loading...
