NCR SelfServ 22e ATM Site Preparation
B006-6902-D000 3
Finally, only the customer can know the full extent of damage which may be caused to his
business by reason of failure of the equipment which is to be installed. For this reason it is
the customer’s responsibility to ascertain the extent of any such possible damage to his
existing or planned business, and to effect, full insurance in respect of it.
Customer Responsibilities
The customer must do or provide the following:
When required by NCR, provide the NCR customer service representative with
appropriate drawings that indicate:
Location of the equipment
Site wiring (power and signal, paths and lengths)
Location of other equipment capable of generating electrical noise,
electromagnetic interference, heat, etc.
Make building alterations necessary to meet wiring and other site requirements.
Provide and install all communications cables, wall jacks, special connectors, and
associated hardware.
Provide and install necessary power distribution boxes, conduits, grounds, lightning
protection, and associated hardware.
Make sure all applicable codes, regulations and laws (including, but not limited to,
electrical, building, safety, and health) are met.
Provide and install auxiliary power or other equipment as required.
Provide storage or service areas as required.
Make sure the environmental requirements of the system/unit are met.
Provide floor coverings and environmental systems that limit or control static
electricity build-up and discharge.
Install the product at a height which meets the accessibility regulations of the relevant
country.
Early SelfServ 22e ATMs do not have a power disconnect device (e.g. on/off switch).
If the ATM does not have the power switch shown in the “Siting the ATM” section
then an easily accessible, switchable, mains socket is required to allow safe isolation
from the power supply, resetting and power cycling of the ATM.
To Next Page
Loading...
Need help?
General
