Other Features
59
Temporary Memory
When a call is abandoned while you are away, or when you fail to store Caller-ID information to Caller-ID
Table because the Table is full, caller’s information will be automatically stored in the Temporary Memory
(up to 70 calls). It can hold a maximum of 10 digits long number and 15 letters long name. When there is
information in Temporary Memory, “EXISTING I.D.” is shown on display. If the Temporary Memory is
full, the oldest Caller-ID information will be automatically deleted and the new information will be stored in
it’s place. Temporary Memory can be used to place outgoing calls or to transfer the information to the Caller-
ID Table.
- On-hook condition
1. Press key.
2. Press .
- The first name and number is displayed.
3. If needed, scroll by pressing (forward) or
(backwards) to find desired number.
- When you reach the end of Temporary Memory, you will
see “LIST END” on the display.
4. Press key when the number is displayed.
- Loop key can be used instead of Line key.
- On-hook condition
1. Press key.
2. Press .
- The first name and number is displayed.
3. If needed, scroll by pressing (forward) or
(backwards) to find desired number.
- When you reach the end of Temporary Memory, you will
see “LIST END” on the display.
4. Press key when the number is displayed.
- The information will be stored in the next available bin.
5. Press key.
- On-hook condition
1. Press key.
2. Press .
CAUTION
•
All Caller-ID information in Temporary Memory will be erased when the system power is turned off.
To place an outgoing call from
Temporary Memory:
8137124
INFRONTIA S/W
THU 27 15:20PM
EXISTING I.D.
To transfer information from
Temporary Memory to the Caller-
ID Table:
8137124
INFRONTIA S/W
THU 27 15:20PM
EXISTING I.D.
THU 27 15:20PM
EXISTING I.D.
To clear all stored information in the
Temporary Memory:
OPAC
#
∗
9 5
LINE
OPAC
#
∗
9 5
HOLD
CLEAR
OPAC
9 6
To Next Page
Loading...
