NEC AK-308 - Page 67

Other Features
61
1. Lift handset or press .
2. Dial .
- If Busy, voice paths may be occupied, or user operates
at extension other than #10.
3. Dial Message No. (1-5) (See Note)
4. Dial . (Recording and timer counting start.)
5. Record a message from handset or microphone.
- If Busy; user dials Message No. other than specific No.
6. Dial . (Recording and timer counting finish.)
Return to Step 3.
- If user dials “#” instead of "
∗
", recording contents will
not be recorded and Dial Tone may be sent.
7. Hang up or press .
- When user hangs up or presses SPK without dial
∗
or #,
the recorded message will be saved.
- When the recording time has passed during message
recording, timer counting will automatically be finished
and the recorded message will be saved.
Note: Ask your supplier for which types of message you should record in Message No. 1-5.
1. Lift handset or press .
2. Dial .
- If Busy, FAXU unit is not inserted in the system., or
user operates at extension other than #10.
3. Dial Message No. (1-5)
4. Dial . (The Message is erased.)
When erasing finished, Dial Tone may be sent.
- If Busy, user dials Message No. other than specific No.
5. Hang up or press .
1. Lift handset or press .
2. Dial .
- If Busy, Voice Paths may be occupied, or user operates
at extension other than #10.
3. Dial VAU Message No. (1-5)
- If user dials FAXU Message No. which was not
recorded, Dial Tone may be sent.
4. Dial .
5. Playback the message from handset or built-in speaker.
- If Busy, user dials Message No. other than specific No.
- When recorded contents has been finished, 1-beep tone
will be sent.
After confirmed, return to Step 3.
6. Hang up or press .
To record an Attendant Message:
To erase an Attendant Message:
To confirm a Attendant Message:
(Extension No.10 only)
(Extension No.10 only)
(Extension No.10 only)
9
6
SPK
0
∗
∗
SPK
SPK
9 6 1
∗
SPK
SPK
9 6 2
∗
SPK