23
3.BASIC OPERATION
Login (DT700 Series Only)
When login mode is activated, following procedure is
required.
Enter login code and press Set Soft key.
(The station number is used as the Login code.)
Enter the password and press OK Soft key.
If the login code is accepted, display changes to
normal idle status.
Logout (DT700 Series Only)
Press the preassigned Logout Feature Key on the
terminal.
Note:
This location is an example.
Note: Logout button is assigned by data setting at
the ECP (Enterprise Communication Plat-
form).
Press the Logout Feature Key on the terminal
again.
Passwd
Login 2000
:
:
Cancel BK Set OK
Passwd
Login 2000
:
:
Cancel BK Set OK
*****
MIC DND >>>
15:39 AM MON 18 JUL 2007
MIC DND >>>
15:39 AM MON 18 JUL 2007
L-OUT >>>
15:39 AM MON 18 JUL 2007
To Next Page
Loading...
