NEC DT800 - Call Holding Procedures; Place Call on Hold; Place Call on Exclusive Hold; Retrieve Held Call

To Place a call on HOLD
Press Hold. Held line wink flashes.
Held station number
HOLD 1212
4:26 PM TUE 13 APR 2020
[ Voice ][ Headset ][ Release ]
Note: If held line appears on other DT Series stations, the
associated LED flashes red slowly.
To Retrieve
… Lift handset or press Speaker key.
… Press held line. Use handset to converse.
Note: Any station with this line appearance can retrieve the call.
If Unanswered
… After preprogrammed time, Automatic Recall is initiated.
… Visual and audible signal (rapid flash and ring burst) is sent to
station that placed call on hold.
Note: Hold shows as a flashing green LED on your phone.
The same line on other phones shows as a flashing red LED.
Recall shows as a flashing green LED on your phone and flashing
red LED on other phones with the same line.
To Place a Call on Exclusive Hold
… Press Hold twice. Line appearance indicates interrupted
wink.
Held station number
E-HOLD 1212
4:26 PM TUE 13 APR 2020
[ Voice ][ Headset ][ Release ]
Note: If held line appears on other DT Series stations, LED
remains steadily lit red.
To Retrieve … Lift handset or press
Speaker.
… Press held line. Use handset to converse.
Note: Only the DT Series that set Exclusive Hold option can
retrieve the call.