NEC Dterm Series i Quick Reference Guide

2
TO ORIGINATE AN OUTSIDE CALL
Lift handset or press Speaker key, receive dial tone.
Dial the Central Office access code, e.g. 9.
Dial desired telephone number.
Use handset or MIC to converse.
TO ORIGINATE AN INTERNAL CALL
Lift handset or press Speaker key.
Receive dial tone.
Dial desired station number.
Display indicates digits dialed.
Use handset or MIC to converse.
TO ORIGINATE A CALL USING SPEED CALLING
(ONE-TOUCH BUTTONS)
Press desired Speed Call button, or press Speaker and Speed Call.
To program:
(Available only on D-term stations with speed calling keys.)
Press Feature button.
Press desired Speed Call button.
Enter desired telephone number or feature code on the keypad. Display indicates digits dialed.
Press Feature again to save the number.
To verify:
Press Feature button.
Press desired Speed Dial button.
Display indicates digits programmed.
NOTE 1: To program a pause, press Recall key as any digit other than the first digit ( displays on
LCD).
NOTE 2: To program a Voice Call, press Transfer key after dialing station number
(V displays on LCD).
TO PLACE A CALL ON HOLD
Press Hold. Held line wink flashes.
NOTE: If held line appears on other D-term stations, the associated LED flashes red slowly.
To retrieve:
Lift handset or press Speaker.
Press held line. Use handset to converse.

NEC Dterm Series i Specifications

General

Type	Digital Telephone
Speakerphone	Yes
Headset Jack	Yes
Dimensions	Varies by model
Weight	Varies by model
Display	LCD
Programmable Buttons	Yes
Power Supply	Powered by the phone system
Memory	Varies by model