English-14
Battery Installation and Replacement
The remote control is powered by two 1�5V AAA batteries� To install or replace batteries:
1� Open the battery cover of the remote control by pushing and pulling it in
the direction of the arrow�
2� Insert two new “AAA” size batteries for the remote control� When replacing
old batteries, push them towards the springs and lift them out�
3� Match the batteries to the (+) and (-) marks in the battery compartment�
4� Insert the bottom of the battery, the (-) side, into the battery compartment
rst, push towards the springs and insert the top of the battery, the (+)
side, into place� Do not force the battery into the battery compartment�
5� Close the battery cover making sure the tabs rest in the corresponding
holes and push down the cover until it clicks shut�
CAUTION: Incorrect usage of batteries can result in leaks or bursting�
NEC recommends the following battery use:
• Do not mix battery brands�
• Danger of explosion if battery is
incorrectly replaced� Replace only
with the same or equivalent type�
• Do not combine new and old
batteries� This can shorten the
battery life or cause liquid leakage
of the batteries�
• Remove dead batteries
immediately to prevent battery
acid from leaking into the battery
compartment�
• Do not touch exposed battery acid
as it may injure skin�
• Remove the batteries if you do not
intend to use the remote control for a long period of time�
To Next Page
Loading...
