H.323 Trunk Document Revision 1
Hardware, Installation and Maintenance Manual A - 13
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 9RESET CARD
A reset is necessary when changing the operating modes and network parameters
(such as IP address, Subnet mask, gateway address, TOS field etc.).
K
Safe reset - When safe reset is selected, the IAD(8)-U( ) will only execute the
reset after all channels or ports are idle.
K
Forced reset - If forced reset is selected, the IAD(8)-U( ) will reboot immediately
preempting any and all channels or ports that are active.
Figure A-9 Resetting the Card
To Next Page
Loading...
