Hardware, Installation and Maintenance Manual D - 1
___________________________________________________________________________________
___________________________________________________________________________________
Appendix D
Electra Elite IPK II IAD(8)-U( ) ETU
Installation
SECTION 1INTRODUCTION
The IAD(8)-U( ) ETU provides the hardware platform for providing Voice Over IP
connectivity for the KTS. By default, this card is shipped from NEC with a "platform
support" (factory default) firmware. A functional firmware is loaded as part of the
installation to support the desired VoIP functionality (for example, H.323 Trunk
package).
In this document, loading of a H.323 Trunk Card package on to the IAD(8)-U( ) is
provided. The same procedure applies for any other application package.
SECTION 2INSTALLING IAD(8)-U( ) ETU PACKAGE
2.1 Description
The IAD(8)-U( ) ETU is an optional interface for the Electra Elite IPK II KSU
that is used as integration device. The IAD(8)-U( ) ETU will support various IP
applications (e.g., IP CCH ETU application, H.323 Trunk card application, and
Megaco Station application).
Refer to Figure D-1 IAD (8)-U( ) ETU.
To Next Page
Loading...
