USERS_GUIDE_1080XD_hw
1-12
3. Enter “s” of the iSP commands.
4. Enter the ESC key.
5. Enter “up” on the SP console.
iSPyz: ---> up<ENTER>
This command will bring up the specified partition.
Enter partition number (0-7/all/CR=exit) : all
<ENTER>
Execute OK? (y/[n]) y
<ENTER>
UP command was accepted. All partitions will run soon.
[iSPyz: INFO.ccc] partition 0 : power on sequence started.
[iSPyz: INFO.ccc] partition 1 : power on sequence started.
:
[iSPyz: INFO.ccc] partition 1 : power on sequence completed normally.
:
[iSPys: INFO.ccc] partition 1 : handed off the control to BIOS.
iSPyz> s<ENTER>
***** SP Command Mode *****
***** enter ESC to do the command input effectively *****
***** enter CTRL+B to quit *****
To Next Page
Loading...
