NEC Express5800 1080Xd - SP Command Console

USERS_GUIDE_1080XD_hw
1-31
1.4.7.4 SP command console
If you select the SP command on the iSP first menu, the SP command console is displayed.
To go back to the first menu from the SP command console, enter “^B” (press “B” while
pressing CTRL). Some SP commands can be only used with the master iSP.
(Screen Image)
Description
code
iSP MAIN MENU
0) OS(BIOS) serial console of partition#0 (INITIALIZING )
1) OS(BIOS) serial console of partition#1 (RUNNING )
2) OS(BIOS) serial console of partition#2 (STOPPED )
3) OS(BIOS) serial console of partition#3 (FAULT )
4) OS(BIOS) serial console of partition#4 (POWER OFF )
5) OS(BIOS) serial console of partition#5 (RUNNING )
6) OS(BIOS) serial console of partition#6 (NOT CONFIGURED )
7) OS(BIOS) serial console of partition#7 (NOT CONFIGURED )
V) Virtual System Operator Panel
S) iSP commands
E) Exit
DISCONNECTALL) disconnect all console connections
iSP yz> S<ENTER>
(a)
:
:
:
:
:
(b)
<CTRL>+<B>
(c)
(Description)
Description
code
Description
(a) If you enter “S”, the SP command console is displayed.
(b) During this period, the SP command input and the SP message output are monitored.
(c)
If you enter “CTRL+B”, the SP command console is closed and the first menu is
displayed again.