NEC Express5800 1080Xd - Power off

USERS_GUIDE_1080XD_hw
1-15
1.4.1.2.3 Power off
After confirming the DC power is off (1.4.1.2.2), you can turn off the AC power. This
section describes the steps to turn off the AC power.
1. Turn off the AC switch in the switch box located at the top in the front panel of the
cabinet.
2. When a full-size PCIX unit is attached, turn off the AC power breaker of PowerBay on
the bottom of the back of the main cabinet.
3. Cut off the power of the uncontrollable external peripheral devices from the main
cabinet.
4. Turn off the AC power breaker in the receptacle box in the main chasis.
5. Turn off the power of the control PC (only domestically).
6. Turn off the distribution board.
1.4.2 Dump Extraction
In case of a trouble, please run the following command from the control PC to extract dump.
For details about the command, please refer to 1.3.6.5.3. DP (System Dump) of the
Hardware volume.
iSPyz: ---> dp<ENTER>