NEC Express5800 320La Release Note

Express5800/320La System Release Notes 9
! Press Esc, select Exit, and select Save Changes & Exit. Press Yes at
the Setup Configuration Screen. The BIOS changes are saved and the
system reboots.
6. Enable the greater than 4GB disc geometry in PCI module 2 as follows.
! As the system reboots, watch for the message “Press Alt Q to enter
“Qlogic Fast!UTIL.” When you see the message, press Alt Q. The Fast!
UTIL Options screen displays.
! Select Select Host Adapter and press ENTER. The Select Host
Adapter screen displays.
! Select QLA12160 Ultra 3 and press ENTER. The Fast!UTIL Options
screen displays.
! Select Configuration Settings and press ENTER. The Configuration
Settings screen displays.
! Select Host Adapter Settings and press ENTER.
! Select >4Gbyte Addressing and change the setting to Enabled.
! Press Esc until the “Configuration settings modified” box displays.
Select Save Changes and press Enter. Press Esc and the Exit
Fast!UTIL box is displayed.
7. Power down the system.
8. Ensure that the locking handle on the front of the PCI module 1 is in the up
unlocked position. See Figure 2-3.
9. Carefully slide PCI module into the chassis until it is firmly seated in its
connector.
10. Swing the locking handle all the way down to its locked position.
Figure 2.3. Securing the Locking Handle of the PCI Module

NEC Express5800 320La Specifications

General

Form Factor	Tower
CPU	Intel Xeon Processor
Storage	SCSI/SATA
Network	Integrated Ethernet
Operating System Support	Windows Server, Linux
Expansion Slots	6 total: 2 x 64-bit PCI, 2 x 32-bit PCI, 1 x shared PCI/ISA, 1 x ISA