EasyManua.ls Logo

NEC LED-E012i-108 - Page 5

NEC LED-E012i-108
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English - 3
This product can only be serviced in the count ry where it was purchased.
CAUTI ON
Do not dam age the power cord. Do not put
heavy objects on it, place it near heat ers, pull
it w ith excessive st rengt h, or apply a st rong
force on it while it is bent.
A damaged power cord may cause a re or an
elect rical shock.
Do not install t he product in narrow places
where heat t ends t o build up.
Do not use t he product in an environm ent
wit h low heat dissipat ion.
Ot herwise, it m ay cause a m alfunct ion.
The RJ- 45 port of t he product is for use
wit h t he product only. Do not connect it t o a
net work. Connecting t his port t o a network
that m ay receive over- volt age current m ay
cause dam age t o the product or an elect rical
shock.
Do not use t he product in a vehicle or anot her
m eans of t ransportat ion.
Do not use or st ore the product in t he
following places.
Near heaters
Places w ith lot s of hum idit y or dust , or
places subj ect to oily sm oke
Places w here water or oil m ay splash
Places w ith lot s of corrosive gases, such as
near hot springs
Places w here t he product m ay freeze
Do not place the product on it s side, face
down, or upside down.
Places w ith lot s of vibrations
I f you will not be using the product for a long
tim e, disconnect it from t he power dist ributor
for safety purposes.
Disconnect t he power supply w hen
perform ing t he m aint enance.
I nst all the product in accordance wit h t he
local laws and regulat ions.
Do not place t he product under direct sunlight
or near heaters.
This product is designed to be used indoors.
Do not use it outdoors. Otherwise, it m ay
cause a m alfunction.

Related product manuals