English−18
4. To keep the cables neatly organized, place them into the cable management system that is built into the stand.
NOTE: Place the cables in the hooks firmly and evenly (Figure C.2).
Figure C.2
Power Cord
USB / Video Cable
5. Please check that you can still raise and lower the monitor screen after you have installed the cables, then slide the cable
cover down.
6. Connect the power cord to a power outlet.
NOTE: • Please refer to the Caution section of this manual for proper selection of the AC power cord (see page 1).
• Please make sure that enough power is supplied to the monitor. Please refer to “Power Supply” in the
“Chapter 5 Specifications” on page 42.
7. Turn on the monitor by touching the key and then turn on the computer.
NOTE: If you have any problems please refer to the Troubleshooting section of this User’s Manual (see page 38).
To Next Page
Loading...
Need help?
General