NEC NEAX 7400 ICS - -200-008 Mounting of Circuit Cards; 008-1 Lamp Indication on PZ-PW86(A) Card; NAP-200-008 Mounting of Circuit Cards; 1. Mounting Procedure

AD-25182501CHAPTER 3
Page 106
Revision 1.0.1
NAP- 200-008
Sheet 1/2
Mounting of Circuit Cards
1. Mounting Procedure
(1) For testing, turn on the “SW” switch on the PZ-PW86/PW86(A) Card(s). Make sure that each “ON” lamp
(Green) is lit.
Note:
This switch also controls the battery feed.
Figure 008-1: Lamp Indication on PZ-PW86(A) Card
PZ-PW86(A)
BATTERY
START
(PZ-PW86(A) only).
“ON” LAMP (GREEN)
MJ
MN
ON
MODE
ON
1
2
AUX PWR
GND
FG
-27V
BATT2
_
+
BATT1
+
_
SW
I
ON
OFF
O
100/120V AC
240V AC
“SW” SWITCH
CAUTION:
Set the appropriate
voltage before turning
on the AC switch.
AC INPUT
TO AC MAINS