NEC NEAX 7400 ICS - 006-2 Example of Existing MDF Cable Running

AD-25182501
CHAPTER 3
Page 63
Revision 1.0.1
NAP- 200-006
Sheet 3/3
Cable Running to MDF
(3) For connection to an existing MDF, bring the MDF cables into the Main Equipment through the cable hole(s)
of the BASE as shown in Figure 006-2.
(4) Plug the CHAMP connector of each cable to its LTC connector located on the PIM, and screw them together.
Figure 006-2: Example of Existing MDF Cable Running
LTC CONNECTOR
CHAMP CONNECTOR
FRONT
TO MDF
BASE
PIM0
PIM1
PABX