AD-25182501CHAPTER 3
Page 44
Revision 1.0.1
NAP- 200-003
Sheet 26/29
Installation of Main Equipment
(2) The AC CORD-A (AC Power Cable) wiring to the PZ-PW86 power unit(s) is shown below for a 2-PIM
system.
Notes:
1. The multi-way AC outlet is not
provided on a single-PIM system.
2. In order to comply with AUSTEL TS001, all AC cords must have additional strain-relief, as shown
in the detail below.
Figure 003-26 AC CORD-A Wiring to BASE
TO TERMINAL
FRONT
AC CORD-A
TO TERMINAL
Tie Bar
cord.
To power-
unit input.
STRAIN-RELIEF DETAIL
cable-tie on the
Additional small
From AC
outlet
Large
Cable-Tie
To Next Page
Loading...
