AD-25182501CHAPTER 3
Page 54
Revision 1.0.1
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
NAP- 200-004
Sheet 7/9
Installation of Peripheral
Equipment
(3) Set the switch located inside the console according to type of headset/handset connected.
Figure 004-6: Access to Switch on SN611 ATTCON
• Slide the directory out of the way.
Then insert a flat screw driver’s blade into the notched opening and apply light upward pressure until
the access panel is clear of the front lip. At the same time apply pressure (toward you) at the rear of
the pedestal to move the access panel.
ACCESS PANEL
DIRECTORY
To Next Page
Loading...
