49
2. Setting Up Your Projector and Chiller Unit
2-1. Setup Procedure
Set up the projector and the chiller unit according to the procedure below. This chapter describes the installation of procedure
until turning on of the power.
Projector
• Step 1
Projector Installation (See page 50)
• Step 2
Selecting the Power Cable (See page 51)
Connecting the Power Cable (See Projector User’s Manual)
• Step 3
Mounting the Lens Unit (See page 57)
• Step 4
Mounting the following optional parts as required.
- Installing the Media Block (NP-90MS02-4K) (See page 60)
Chiller unit
• Step 1
Connecting the Power Cable for the Chiller Unit (See page 64)
• Step 2
Connecting the Hoses for the Chiller Unit (See page 71)
Connecting the Control Cable (See page 73)
• Step 3
Pouring the Coolant (See page 74)
• Step 4
Setting the Chiller Unit (See page 76)
Connection schematic diagram
AC power facilities
AC power cable
AC power cable
Projector
Hose for chiller unit
Control cable
Circuit breaker
Electrical outlet
Chiller unit
Circuit breaker
To Next Page
Loading...
