77
Setting Up Your Projector and Chiller Unit
NOTE
If an error occurs in the chiller unit, one of the following error codes is displayed on the status display.
Turn off the projector and the chiller unit, Inquire your dealer about action to be taken for each error code.
• E02: Chiller unit pump motor error
• E03: Chiller unit pump compressor error
• E04: Coolant pressure too high / Coolant is higher.
• E06: Low coolant pressure
• E07: Coolant flow rate error
• E08: Heat sink system error
2-10-2. Fixing the Chiller Unit
After placing the chiller unit at a desired installation location (see page 33), push the knob of each caster and lock the caster to
fix the chiller unit. To unlock each caster, push the knob again.
Caster
Knob
To Next Page
Loading...
