NEC NP-17CU01 - Display the Test Pattern

85
Projector Adjustment and Connecting
3-6-2. Carry out Calibration of the Lens
If you have attached a lens unit that supports the lens memory function, always execute calibration before making adjustments.
Preparation:
• Check that the lens is attached correctly (page 57).
• Set the lens type (page 84).
1
Press the MENU button on the control panel.
“Title Select” is displayed in the menu.
2
Press the LEFT/RIGHT button to display “Conguration” and press the DOWN button.
3
Press the LEFT/RIGHT button to display “Installation” and press the DOWN button.
4
Press the LEFT/RIGHT button to display “Lens Calibrate” and press the DOWN button.
5
Check that “Execute” is displayed and press the ENTER button.
The confirmation screen will appear.
6
Select “Yes” in the conrmation screen, and then press the ENTER button.
Carry out calibration in the order of focus lens and zoom lens.
3-6-3. Display the Test Pattern
1
Press the MENU button.
“Title Select” is displayed on the LCD screen at the projector’s control panel.
2
Press the DOWN button.
3
Press the LEFT/RIGHT buttons to select “TEST Pattern”.
4
Press the DOWN button.
5
Press the LEFT/RIGHT buttons to select “Cross Hatch”.
6
Press the ENTER button.
An (*) will be put on the selected test pattern.