68
Setting Up Your Projector and Chiller Unit
Connecting the Cable
In order to attach the power cable to the connector block, connect the wires using the following procedure such that the indi-
vidual wires cannot directly touch each other.
Remove the power cable sleeves from the terminals to
ensure that the sleeves are not pinched by the terminal
attachment screw.
Pull back the sleeves from the terminal area before fastening the screw
to prevent the sleeves from being pinched.
Attach the sleeves after tightening the screw.
Tighten the fixing screw to the designated torque.
Use sleeves and secure the insulation to ensure that terminals do not touch
each other. If the cables are attached to the power supply terminal without
using sleeves, there is a risk of the terminals touching each other as shown in
the photograph on the right.
When connecting the cables to the ground terminal block, ensure that parts other than the solderless terminal (such as cable
wires and fittings) are not pinched within the terminal fastening area.
When correctly fastened When the cable wire has become pinched due to using a solderless
terminal with dimensions other than as designated.
Sleeves
To Next Page
Loading...
