NEC NP-17CU01 - Page 70

70
Setting Up Your Projector and Chiller Unit
4
Raise the arm of the ground terminal.
Loosen the grounding terminal screw with a flathead screwdriver and lift the arm.
Screw
5
Insert the ground cable into the ground terminal.
Insert the crimp terminal of the ground cable to the connecting terminal of the ground terminal.
Arm
Connecting terminal
WARNING
Firmly tighten the ground cable to the connecting terminal. After tightening all screws, check that all power cables are
properly tightened and in place. If the screws are not firmly tightened, this may cause serious personal injury or even death.
6
Return the arm in the reverse procedure, screw the ground terminal.
Return the arm and tighten the screw of the ground terminal with a flathead screwdriver.
7
Install the cover plate of the chiller unit.
Mount the cover plate, and secure with screws (four locations).