NEC NP1250 - Desktop Control Utility 1.0

11
1. What You Can Do with User Supportware 6
What You Can Do with User Supportware 6
1
1-2. Desktop Control Utility 1.0
Desktop Control Utility 1.0 is software that operates the desktop screen of a personal computer
at a remote location from the projector by using a network.
l A commercially available USB mouse is connected to the projector to operate the personal
computer.
l Suppose, for example, a PowerPoint file to be presented in a conference is saved to a
personal computer in your office. If this personal computer is connected to the projector
in the conference room with LAN when the conference is held, the desktop screen of the
personal computer in your office (Windows Vista/Windows XP/Windows 2000) can be
projected and the PowerPoint file can be presented by operating the projector. In other
words the personal computer does not need to be brought into the conference room.
Important
LAM
P
STATU
S
PO
W
ER
ON/
S
T
A
ND
BY
SOURC
E
AUT
O ADJUST
3D R
EFO
RM
SELE
CT
U
SB
LENS
S
HIFT
LE
FT
R
I
GHT
DOWN
U
P
WIRELESS
WIRELESS
Conference room
Office
• You can use the Desktop Control Utility 1.0 to operate a personal computer located in
a separate room from the projector over a network. Therefore, care must be exercised
to prevent any third party from viewing the screen of your personal computer (important
documents), copying files, or turning off the power.
NEC assumes no liability for any loss or damages arising from information leaks or
system failures while you are using Desktop Control Utility 1.0.
• In the Windows operating system, select [Control Panel] → [Hardware and Sound] →
[Power Options]. Set [Change when the computer sleeps] to [Never] (in the case of
Windows Vista). This will disconnect the LAN connection when the personal computer
enters standby mode while the Desktop Control Utility 1.0 is being used.
• The screen saver function is turned off while Desktop Control Utility 1.0 is running.